Handyman Services Houston Tx

How to Install Garage Door

Remove the Old Door

Exploit the manufacturers’ directions of Garage door repair to remove the previous door. It chiefly consists of cautiously unlatching the door from the pulley structure, then taking to one side the panels of the door and unscrewing the tracks. Be confident to remove one board at a time, or the garage door  can all fall  on you.

garage door repair houston

 Measure, Attach Hinges and Handles

Calculate the various areas where the entrance will be installed: door-opening altitude and width, headroom , and rear space (length of garage door repair). For the headroom, you must have about 10 to 12 of gap, depending on the spring structure you’re installing. For the backside room, you should have the door tallness, plus an extra 18″ or more of room.

By means of the appropriate measurements in hand, provisionally connect stops to mutually sides of the gap and be sure they are flush with the contained by edge of the door jamb. Using the sawhorses, put down out the base piece of the new door, and attaches any type of weather stripping (if necessary). As well, join any hinges and lift handles to the part.

 Set the Bottom Piece Into Position

Insert the bottom piece into the door edge, and use a level to properly adjust the piece. Once the piece is in place, tap nails partway into each jamb. Slant or slightly bend the nails to secure them in place. Use the manufacturer’s directions to assemble the vertical, bent and horizontal pieces of the track and set aside.

garage door repair houston

 Install the Remaining Panels

fit the next panel on top of the initial one, hammering nails into the side jambs to hold it place. put in the hinges and do again the process for however numerous panels are necessary. You will require to fasten every piece into the entrance jamb.

 Install the Rollers

Once all the sections are protected, fix the rollers in the section’s roller chains in garage door repair. By means of these in position, place the rollers in the assembled pathway, securing the track’s brackets as you go next to. Be cautious not to include the rollers pressed too firmly against the path because friction can origin damage to the gate.


Secure the Tracks and Attach the Springs

Along with the perpendicular tracks protected against the jambs, fit the curved and horizontal pieces. When installing the flat pieces, use your prior measurements and level to make sure the tracks are straight and that they are pointing away from the opening at 90 degrees.

Now that the tracks are secured, accumulate the springs according to the manufacturer’s commands. With the aid of a partner, lift the door to about half length to get sure the tracks are level and parallel. If you’re all set, raise the garage door repair the residual distance and attach the springs to the pulley structure.

Also Read:

Handyman Houston solve all your House problems by MightyDoes

Quality Control Handyman Service Houston by MightyDoes


This entry was published on March 8, 2014 at 12:08 PM. It’s filed under Bathroom Remodeling Houston, Commercial Maintenance Services, Drywall Repair Houston, Electrical Services Houston, Handyman Houston, Handyman Services, Handyman Services Houston, Handyman Services Houston TX, Home Maintenance and Repair Services, Home Remodeling Contractors, Home Repair Houston, Kitchen Remodeling Houston, Leak Repair, Pest Control, Plumbing Services Houston, Remodeling Services, Remodeling Services Houston, Residential Maintenance Services, Sheetrock Repairs Houston, Stucco Repair Houston and tagged , , , , , , , , , , , , , , , , , , , . Bookmark the permalink. Follow any comments here with the RSS feed for this post.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )


Connecting to %s

%d bloggers like this: